Sydney Tiles Facebook Sydney Tiles Twitter Sydney Tiles Instagram Sydney Tiles Youtube Sydney Tiles Facebook
 

Drilling Porcelain Tiles – Step-By-Step Guide

Do you wish to learn how is drilling porcelain tiles done? This post will assist you by providing clear steps that will be imperative for your drilling process. Drilling porcelain tiles will be required should you want to put up fixtures in your bathroom or virtually any room that has porcelain tiles. For example, by drilling the porcelain tiles, you’ll be able to put bathroom shaving cabinet, a mirror, soap dish, towel rails, or possibly your skin care products holder.

To start your drilling activity, you have to first figure out what type of resources you should have to carry out the work. Take a look at the equipments you will require:

RCD Breaker
Drill Bits of Diamond Core (High Quality)
Masonry Drill Bits (Included w/ quality drill bits)
Drill Bit of Carbide Pilot ( use this if you will drill 13-mm hole or bigger holes)
Equipment for Water Cooling
Drilling Device
Safety Glasses or Goggles

These materials can be bought in various stores. You can just simply buy these before proceeding to your drilling activity. You must be sure of the standard of the tools first to ensure the output of the drilling can be suited to your requirement.

Yet another thing you must think about with drilling porcelain tiles is the hole sizes you are about to create. It is fairly important for the size or diameter of the hole determines how large the drill bit you’re going to use.

After selecting the diameter of the holes you’re going to drill and setting up the instruments you will need for the drilling, you can begin to proceed drilling your porcelain tiles. Make sure to put on your safety goggles to keep your eye away from particles and elimination of electric shock with RCD.

These proceeding steps will be for holes about 10mm or less in diameter using diamond cores.

1. Put an indicator at the hole’s center. Either you use a sticky tape or perhaps lead pencil.
2. Find the appropriate size of the diamond core bit. After that, affix it to the electric drill. Make sure that there is a supply of water from any cooling gear is at a constant. (Water cooling equipment is important in keeping it certain that there’s a constant cool temperature in the diamond core bit and this will prevent debris while you are drilling the hole. Don’t use mobile aspirator or wet sponge, for these never provide sufficient coolant to the diamond core bit.)
3. Your drill must be positioned between 1000 & 1500 rpm. Choosing the marker as your marking tool, it is ideal to apply the “Leaning In” method.
*Method of Leaning In- With an angle, you’ll begin to drill. As you see the drill cuts the tile, your drill has to be in horizontal position. Ensure there’s adequate pressure laid and rotate the drill till the hole is completely drilled.
*Method using Sticky tape- Set sticky tape on the wall where you need the hole. It will help to prevent the drill bit from sliding.
4. Tip- I picked up a great from www.tfo.com.au. When the hole has started, don’t use a lot of pressure have the drill carry out the work.

0 comments… add one

Leave a Comment